If you don't do this, Serial Read/Write blocks and PIL will not work. That doesnt line up with the Simulink 2012b version that I am running with. A tutorial that I have found (using v3.3) directs me: >Target Support Package >C280xx and then to drop the Piccolo MCU that I am using into my model. This package uses HW UART (see inscription on the board). I am trying to learn to use Simulink to interface with Code Composer Studio v5. Make sure there are no spaces/non-ascii characters in path (just in case).ī) Make sure you have a working/supported host compiler ( ) by running 'mex -setup' in MATLAB.Ĭ) Within MATLAB, 'cd' to the directory containing launchpad_setup.m and run this script.ĭ) Swap TX/RX jumpers on TI LaunchPad (see the group of 5 jumpers on your board). Make sure your toolchain is working (build and download some test project, check connection)Ģ) a) Extract this package somewhere. On Linux, you can use mspgcc toolchain instead of CCSv5. Therefore, you will also need mspdebug ( ) on Linux toĭownload/debug after compiling with CCSv5 toolchain. Note: Currently Code Composer Studio 5 for Linux doesn't support LaunchPadĬonnection/debugging.
Generate C code and deploy your algorithms to target hardware.ġ) Windows/Linux: Have Code Composer Studio 5 installed ( ). TI LaunchPad ( ) is an easy-to-use, affordable (< 5 USD),Īnd scalable introduction to the world of microcontrollers and the MSP430 family.įor multidomain simulation and Model-Based Design. Simulink (Embedded Coder) Target for TI LaunchPad
0 kommentar(er)
